Coder Cards#
The VEX GO Coder cards reference explains what each Coder card does and how it can be used in a project. In the VEX Digital Coder, Coder cards offer a way to code the VEX GO robot without typing or building blocks. Each Coder card represents a command, and when placed in the Digital Coder, it will instruct the robot to complete a behavior.
Use this reference when you want to understand a card before adding it to a project, or compare similar cards of the same type.
Building a Project with the Digital Coder#
Every project begins with the when start GO card in the top slot of the Digital Coder, marked with a white arrow.
Drag cards into the numbered slots below it, or select a card and then select a slot. The Digital Coder reads the project from top to bottom.
Fill the slots in order. The project stops at the first empty slot, and any cards after it do not run.
Select the Start button on the Digital Coder to run the project. The light beside each slot glows green as the robot runs that card.
The Motion cards for the motor and the Magnet cards both use the device connected to port 3, so a project can use one kind or the other, but not both.
Card Types#
Each type of Coder card is a different color.
Card Type |
Color |
What the cards do |
|---|---|---|
Blue |
Drive and turn the robot, and spin the motor connected to port 3. |
|
Purple |
Control the color that the LED Bumper will glow. |
|
Green |
Pick up and drop objects with the Electromagnet connected to port 3. |
|
Orange |
Control the flow of the project and allow the robot to make decisions and repeat cards. |
|
Red |
Start, loop, or end a GO project. |
|
Gray |
Control a focused amount of time for the robot to wait until the following action is executed, or make it wait for the LED Bumper or Eye Sensor. |
How to Read a Card Entry#
Each card entry includes the following parts:
Card description - Explains what the card does.
Card image - Shows what the card looks like.
Example - Shows one way the card can be used in a project, with the cards in order from the top slot of the Digital Coder to the bottom.